PSA is very pleased to announce the addition of the Krohne product line to our product offering. Krohne offers world class flow and level measurement products; Krohne has nearly 2500 employees on 5 continents.

An example of one of their products is the UFM 3030 inline, ultrasonic flowmeter

The UFM 3030 is a 3-beam ultrasonic flowmeter for liquids. UFM 3030 measures independent of conductivity, viscosity, temperature, density and pressure.

Highlights

• Three beams generate a measurement effectively independent of flow profile
• Optional pressure and temperature inputs for calculation of standardised volumetric flow or mass flow according to API 2540 or customer specifics
• Over 20.000 ultrasonic flowmeters installed worldwide
• Easy to install and operate
• No moving or intruding parts, no wear, no drift, therefore no additional pressure loss
• No material build-up as unobstructed flow sensor with smooth surface finish
• No periodic re-calibration or maintenance
• Insensitive to corrosive or abrasive products
• Excellent long-term stability and reliability

> Click here for more information

Practical Instruments consists of a world-class team headed by the former Director of Engineering of Altek©, Ron Clarridge. The combined experience and knowledge within the industry of the team enable us to produce practical instruments of exceptional quality.

We understand what the industry is looking for in handheld calibrators. An example is the model Patented model 532 !

Model 532

4-20 mA/Voltage Loop Calibrator with Loop Diagnostics

The BEST Milliamp Calibrator on the Market

The Practical Instrument Electronics (PIE) Model 532 is the best tool for calibration, test, and diagnosing process loops. The Model 532 brings all the features you would expect from a loop calibrator and times new romanaving new ones. Make adjustments with the EZ-Dial™ knob or test limits with the Dual Action EZ-Check™ switch.

Powerful ramping functions are only a button away on the Model 532. Save potentially hours of troubleshooting time on problem loops with the Model 532’s unique Loop Diagnostic Mode, only available at PIE! In Loop Diagnostic Mode, the loop current, voltage, impedance, AC voltage, and mode of operation are all displayed simultaneously eliminating the need of a DMM connection.

Loop diagnostics is available in every mode of operation and truly is a diagnostic monitor, as parameters are continuously updated in real time. The smart diagnostic tool even indicates the most likely cause of loop failure! Loop Diagnostic features the ability to measure ground fault error caused by faulty wiring, flooded conduit and corrosion bridges.

So ask yourself, Is your loop REALLY Calibrated?

• True ±0.012% of reading accuracy
• Source and Read 0.000-24.000 mA
• Simulate 2-Wire Transmitters
• Power 2-Wire Transmitters and Read 0.000-24.000mA
• Display current in mA or -25.00-125.00 % of 4-20 mA
• Read 0.00 to ± 30.00 VDC with 4X over range ability
• Source 0.000 to 24.000 VDC with up to 20mA output
• Direct Calibration 1.000V to 5.000V
• Auto Step or Ramp
• Selectable step sizes, time in-between steps & soak time
• Stop watch like EZ-Check™ switch
• Full 5 Digit Display
• Uses 1 – 9Volt alkaline battery
• Superior battery life of 40 hours under typical continuous usage
• Easy access to battery compartment
• 240 VAC Tolerant
• HART® protocol compatibility mode
• Power on selectable 250 ohm resistor in series with the output for compatibility with HART® protocol enabled devices.
• AC adaptor, carrying case, and Test Data available
• NIST Traceable Calibration Certificate included FREE